Handling Rolls; Selecting The Roll As The Paper Source - Canon imagePROGRAF iPF6100 User Manual

Handling rolls

Selecting the Roll as the Paper Source

You can switch the paper source between the roll and the sheet by pressing the Feeder Selection button.
Each time you press this button, the paper source switches between the roll (indicated by the Roll Media
lamp ) and the sheet (indicated by the Cut Sheet lamp ).
Press the Feeder Selection button to activate the Roll Media lamp (a).
Caution
•
Paper jams may occur if you load paper other than the paper specied in the paper settings for the
media source.
Note
•
You cannot switch the paper source in the following situations:
•
If the Message lamp is ashing
Check the message on the Display Screen and take action as necessary. (→P.687)
•
If the Data lamp is ashing
Select the paper source after printing.
•
If a printer menu operation is in progress
Select the paper source after the menu operation.
•
When in the process of loading paper
Finish loading the paper before selecting the paper source.
•
When in the process of replacing Ink Tanks
Finish replacing the Ink Tanks before selecting the paper source.
•
If the Top Cover is open
Close the Top Cover before selecting the paper source.
After you select the roll as the paper source, a message is displayed instructing you to load the roll. At this
point, load the roll. (→P.119)
Note
•
If any paper is loaded that will not be used, remove it before loading the roll.
(→P.122)
(→P.164)
Handling rolls
Handling Paper 115