Using Pcl Color Mode - Set Pcl Color Setting - Brother HL-1070 - B/W Laser Printer Technical Reference Manual

2.2.

Using PCL Color Mode - Set PCL Color Setting

Command
ESC*v#W (27)(42)(118)#(87)
# = 6, 18
# stands for the number of bytes of data that follow this command.
This command sets the palette size and transformation between the entered value and device-specific value.
This command has two types of format, short format and long format. Here are the formats for the PCL color
setting.
1) Short Format
MSB
0 - 1
2 - 3
4 - 5
Format
This value must be 0.
Encoding mode
This value defines how to send the raster image data.
The value can be from 0 to 3 only, other values are ignored.
Encoding Mode
0
1
2
3
* = default
Send Index No by Plane (= 0 default)
This mode assigns the Index No. to the Plane, then sends it.
The necessary number for the Plane is determined depending on the number of bits/index. 1 (one) plane
should be needed per 1 (one) bit/index. For instance, 4 planes are needed for 4 bits/index.
Bits/index must be 1, 2, 4, 5, 6, 7, 8.
This mode sends the plane data except the last one using the Send Raster Data by Plane command
(ESC*b#V).
This mode also sends the last plane data using the Send Raster Data command (ESC*b#W).
(i.e. 4 bits/index)
ESC*b#V d1, d1, d1, d1, d1 ...
ESC*b#V d2, d2, d2, d2, d2 ...
ESC*b#V d3, d3, d3, d3, d3 ...
ESC*b#W d4, d4, d4, d4, d4 ...
ESC*b#V d1, d1, d1, d1, d1 ...
ESC*b#V d2, d2, d2, d2, d2 ...
MSB
Index No. d4
** The Italic characters shown above are the index No. at the 4th pixel in the 1st raster.
<1Bh><2Ah><76h>#<57h>
Format (0)
Bits / index
Bits / value #2
Send Index No by Plane *
Send Index No by Pixel
Send Direct Value by Plane
Send Direct Value by Pixel
d3 d2
CHAPTER 3 "PCL5C" - 5
LSB
Encoding mode
Bits / value #1
Bits / value #3
Plane 1 1st raster
Plane 2
Plane 3
Plane 4
Plane 1 2nd raster
Plane 2
LSB
d1
2001/10/02