Brother HL-1070 - B/W Laser Printer Technical Reference Manual page 136

2001/10/02
[Example]
If you want to send index No. 7,6,5,4,3,2,1,0;
Enter 'ESC*v6W 00h 00h 04h 08h 08h 08h', then select Send Index No by Plane.
Select 4 bits/index. (2
ESC*r1A
ESC*b1V 10101010B
ESC*b1V 11001100B
ESC*b1V 11110000B
ESC*b1W 00000000B
....
ESC*rC
Send Index No by Pixel (= 1)
This mode sends the index No. by pixel.
Bits/index must be 1, 2, 4, 8.
(2 bits/index)
** The Italic characters shown above are the index No. at the 2nd pixel in the 3rd raster.
[Example]
If you want to send the index No. below;
Index No.
3, 2, 1, 0
2, 1, 0, 3
3, 0, 1, 2
0, 1, 2, 3
Enter 'ESC*v6W 00h 01h 02h 08h 08h 08h', then select Send Index No by Plane.
Select 2 bits/index. (2
ESC*r1A
ESC*b1V 11100100B
ESC*b1V 10010011B
ESC*b1V 11000110B
ESC*b1W 00011011B
....
ESC*rC
Send Direct Value by Plane (= 2)
This mode sends each value of RGB by plane.
Bits/index must be 1.
This mode sends the plane data except the last one using the Send Raster Data by Plane command.
This mode sends the last plane data using the Send Raster Data command.
4
= 16 Palettes)
(xxh: hexadecimal, xxxxxxxxB: binary)
ESC*b#W d1, d2, d1, d2, d1, d2...
ESC*b#W d1, d2, d1, d2, d1, d2...
ESC*b#W d1, d2, d1, d2, d1, d2...
ESC*b#W d1, d2, d1, d2, d1, d2...
MSB
Index No. d2 d1
(1st raster)
(2nd raster)
(3rd raster)
(4th raster)
2
= 4 Palettes)
(xxh: hexadecimal, xxxxxxxxB: binary)
CHAPTER 3 "PCL5C" - 6
Start Raster Transfer
Send Plane1 data (The Index No Bit0 data)
Send Plane2 data (The Index No Bit1 data)
Send Plane3 data (The Index No Bit2 data)
Send Plane4 data (The Index No Bit3 data)
End Raster Transfer
1st raster
2nd raster
3rd raster
4th raster
LSB
Start Raster Transfer
Send 1st raster data
Send 2nd raster data
Send 3rd raster data
Send 4th raster data
End Raster Transfer