Replacing The Full Mini-Card - Dell Alienware M15x - GAMING NOTEBOOK - COSMIC Service Manual

Replacing the Full Mini-Card

1. Follow the instructions in "Before You Begin" on page
2. Remove the new full Mini-Card from its packaging.
CAUTION: Use firm and even pressure to slide the card into place. If you
use excessive force, you may damage the connector.
3. Align the notch on the card with the tab on the connector.
4. Insert the full Mini-Card at a 45-degree angle into the appropriate system
board connector. For example, the WPAN card connector is labeled WPAN
and so on.
5. Press the other end of the full Mini-Card down into the slot on the system
board until it clicks into place.
6. Connect the blue antenna cable to the full Mini-Card you are installing.
7. Replace the palm rest (see "Replacing the Palm Rest" on page
8. Replace the memory module(s) (see "Replacing the Memory Module(s)" on
page 23).
9. Replace the hard drive (see "Replacing the Hard Drive" on page
6.
10. Replace the compartment door (see "Replacing the Compartment Door" on
page 14).
11. Replace the battery pack (see "Replacing the Battery Pack" on page
CAUTION: Before turning on the computer, replace all screws and
ensure that no stray screws remain inside the computer. Failure to do
so may result in damage to the computer.
12. Install the drivers and utilities for your computer, as required.
NOTE: If you are installing a communication card from a source other
than Dell or Alienware, you must install the appropriate drivers and
utilities.
39).
CHAPTER 11: WIRELESS MINI-CARD(S)
18).
11).
049
/
049