Replacing The Processor - Dell Alienware M15x - GAMING NOTEBOOK - COSMIC Service Manual

Replacing the Processor

1. Follow the instructions in "Before You Begin" on page
CAUTION: Ensure that the cam lock is in the fully open position before
seating the processor. Seating the processor properly in the ZIF socket
does not require force.
CAUTION: A processor that is not properly seated can result in an
intermittent connection or permanent damage to the processor and
ZIF socket.
2. Align the pin-1 corner of the processor so that it points to the triangle on the
ZIF socket, and insert the processor into the ZIF socket.
When the processor is correctly seated, all four corners are aligned at the
same height. If one or more corners of the processor are higher than the
others, the processor is not seated correctly.
CAUTION: To prevent intermittent contact between the ZIF-socket cam
screw and the processor when removing or replacing the processor,
press to apply slight pressure to the center of the processor while
turning the cam screw.
3. Tighten the ZIF socket by turning the cam screw clockwise to secure the
processor to the system board.
CAUTION: If the processor, processor fan and heat sink assembly, or
system board is replaced, use the thermal cooling pads provided in the
replacement kit to ensure that thermal conductivity is achieved. Do
not reuse the old thermal cooling pads.
4. Peel the backing off the new thermal cooling pads in the kit and adhere the
pads to the portions of the processor fan and heat sink assembly that cover
the processor.
6.
5. Replace the processor fan and heat sink assembly (see "Replacing the
Processor Fan and Heat Sink Assembly" on page 54).
6. Replace the right air-vent (see "Replacing the Air Vents" on page
7. Replace the center control cover (see "Replacing the Center Control Cover"
on page 31).
8. Replace the memory module(s) (see "Replacing the Memory Module(s)" on
page 23).
9. Replace the hard drive (see "Replacing the Hard Drive" on page
10. Replace the compartment door (see "Replacing the Compartment Door" on
page 14).
11. Replace the battery pack (see "Replacing the Battery Pack" on page
CAUTION: Before turning on the computer, replace all screws and
ensure that no stray screws remain inside the computer. Failure to do
so may result in damage to the computer.
CHAPTER 13: PROCESSOR
43).
18).
11).
058
/
058