Introduction - HP A5272A - SureStore E Disk System SC10 Storage Enclosure Service Manual

IMPORTANT
Installation (HP-Qualified Personnel Only)

Introduction

Introduction
The following steps are required to install the disk system. This chapter
describes the differences between the installation for the HP SureStore E
Carrier-Grade Disk System SC10 and the standard HP SureStore E Disk
System SC10. The HP SureStore E Carrier-Grade Disk System is a DC
powered NEBS 3 compliant system.
For NEBS compliance, the product must be installed in a NEBS certified
rack and should have a 1U gap above & below the unit. 2 x 1U filler
panels are shipped with the enclosure to allow for this spacing in the
rack.
For installation of the disk system, you will also need to refer to the
HP SureStore E Disk System SC10 User and Service Guide, as well as
this addendum. The following task list identifies where to find the
installation instruction for each step of the installation process.
Preparation
See "Preparation" on page 16.
Step 1: Required Tools
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 2: Unpack the Product
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 3: Installing the Disk System
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 4: Prepare Rack Front
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 5: Install the Disk System
See the HP SureStore E Disk System SC10 User and Service Guide.
14 Chapter 2