Removal and Replacement
Removing and Replacing the Power Supply
Figure 5-3
Power Supply Removal and Replacement
5. With the handle down, slide the replacement power supply into the
6. Rotate the handle up to draw the power supply the last 3/8 inch into
7. Tighten the screw in the power supply handle.
8. Plug the power and alarm connectors into the power supply. See
NOTE
Make sure the cable connector clamps are locked in place for proper
9. Monitor the power supply LED. It should turn green. If the LED is
34
empty slot. The power supply begins to engage the backplane with 3/8
inch (8mm) still exposed.
the chassis and firmly seat the power supply on the backplane. The
power supply should be flush with the edge of the chassis.
Figure 5-1 on page 32
strain relief.
dark or stays amber, see the Troubleshooting chapter in the HP
SureStore E Disk System SC10 User and Service Guide.
Chapter 5