Step 6: Install BCCs
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 7: Set DIP Switches
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 8: Connect SCSI and Power Cables
NOTE
Step 9: Connect To DC Power
See "Connect To DC Power" on page 18.
Step 10: Install Disks
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 11: Turn on the Disk System
See the HP SureStore E Disk System SC10 User and Service Guide.
Step 12: Verify Devices on the Host
See the HP SureStore E Disk System SC10 User and Service Guide.
Chapter 2
Installation (HP-Qualified Personnel Only)
See the HP SureStore E Disk System SC10 User
and Service Guide. Disregard the information on
connecting to AC power. This does not apply to
this product. See "Connect To DC Power".
Introduction
15