Table of Contents
Advertisement
3 If you are replacing the ribbon cartridge, grasp the
sides of the cartridge at either side of the printhead
(Caution! printhead can be HOT!), then lift the used
cartridge out and discard it.
4 With the knob side up, tilt the new ribbon cartridge onto
the printhead plate so that it slides into the area of the
plate that is closest to the front of the printer, then lower
the ribbon shield over the printhead (Caution! Printhead
may be HOT!), aligning the tabs with the inserts on the
printhead plate.
✔ If the ribbon won't load easily, turn the knob slightly
until the x-shaped notch on the bottom of the ribbon
cartridge aligns with the x-shaped insert on the ribbon
plate.
5 Press on the cartridge until you feel it snap into place.
6 If you are replacing the ribbon cartridge, put the access
cover back on and press down until it snaps into place,
then replace the acoustic cover.
Printer Handbook: English
|
9
Advertisement
Table of Contents
