Table of Contents
Advertisement
7 Pull up the lock levers (1) to release the tractors and
open the tractor covers (2).
✔ The pins (1) at either end of the platen are not used
with the pull tractor installed. Please leave them
locked in place.
|
18
Setting Up
8 Slide the tractors to align them with the edges of the
paper, then set the paper holes on the tractor pins (1).
Make sure the paper covers the groove on the left side
of the platen, then slide the tractor guide (2) to the
center of the paper.
9 Adjust the tractors so that the paper holes are centered
on the pins, then close the tractor covers.
The paper may jam or cause other problems if it is
stretched too tightly or left too loose on the pins. If
the sprocket holes stretch or tear during printing,
readjust the pins.
Advertisement
Table of Contents
