Table of Contents
Advertisement
4 Push the paper lever back (single sheet position).
5 Insert a single sheet of paper.
6 Remove the access cover and open the bail lever.
7 Use the platen knob to wind the paper through to the
front of the printer, guiding it under the open bail, then
close the bail lever.
8 Use the platen knob to adjust the place on the sheet
where the first line of printing will begin (top of form).
The top of form you have selected will be set
automatically when you turn the printer on.
✔ If the printer is on, press the TOF SET button while
the printer is deselected (SELECT light off) to set
the position as the top of form.
9 Replace the access cover.
10 Press the SELECT button to reselect the printer (the
SELECT light will come on).
|
20
Setting Up
Switching Back to Continuous Forms
1 Open the bail lever and move the paper lever to the
continuous forms position.
2 Remove the printed sheet from the printer.
3 Load the continuous forms paper (see the appropriate
section under Load Paper in this manual).
Run the Self Test
Hold down the LINE FEED button while turning on the
printer.
✔ The first line of the self test contains information on the
version printer you're using. If you should call for
information or service, please have a self-test printout
handy so that our customer Service Representative can
determine exactly what model printer you have.
Advertisement
Table of Contents
