IBM System x3800 Type 8865 User Manual page 38

To install a hot-swap power supply, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Remove the power-supply filler from the power-supply bay:
3. Pull the handle on the power supply to the open position.
4. Place the power supply into the power-supply bay in the chassis and close the
26
IBM System x3800 Type 8865: User's Guide
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the
following label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts
inside these components. If you suspect a problem with one of these parts,
contact a service technician.
2nd power
supply (PS2)
1st power
supply (PS1)
on page 21.
Attention: Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which could
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when working
inside the server with the power on.
a. Press the release latch on the power-supply filler handle and pull the handle
to the open position.
b. Pull the power-supply filler out of the bay.
power-supply handle.
Fan filler
Fan filler
AC
DC
3rd power
supply (PS3)
Fan error
LED
AC power
LED (green)
DC power
LED (green)
Handle
(open)
Release
latch