Installing A Remote Supervisor Adapter Ii Slimline - IBM x3350 - System - 4192 User Manual

10. Insert the hard disk drives that you removed in step 3 on page 34 fully into the
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 38.

Installing a Remote Supervisor Adapter II SlimLine

An optional Remote Supervisor Adapter II SlimLine can be installed only in a
dedicated connector on the system board. After the Remote Supervisor Adapter II
SlimLine is installed, the systems-management Ethernet port on the rear of the
server is active.
To install a Remote Supervisor Adapter II SlimLine, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords and
3. If an adapter is installed in the riser-card assembly in slot 2, grasp the riser-card
4. Turn the Remote Supervisor Adapter II SlimLine so that the connector on the
36
IBM System x3350 Types 4192 and 4193: User's Guide
c. Press firmly until the backplate is fully seated.
9. Route the signal cable from the backplate, through the cable clip on the
system board, and connect it to the signal connector on the SAS/SATA
controller. Connect the power cable to the power backplane.
bays (see "Installing a hot-swap hard disk drive" on page 26 for instructions).
on page 20.
all external cables. Remove the cover
assembly at the rear edge and lift to remove it from the server. Place the
riser-card assembly on a flat, static-protective surface.
adapter aligns with the connector on the system board.
Front mounting bracket
retention latch
Front mounting bracket
Remote Supervisor Adapter II SlimLine
Rear mounting bracket