Installing An Optional Serveraid-Mr10I Sas/Sata Controller (Hot-Swap Models) - IBM x3350 - System - 4192 User Manual

10. Connect any cables to the adapter.
11. Perform any configuration tasks that are required for the adapter.
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 38.
Installing an optional ServeRAID-MR10i SAS/SATA controller (hot-swap
models)
The standard SAS/SATA controller that is installed in the server provides level 0 and
level 1 RAID support. You can replace this controller with an optional
ServeRAID-MR10i SAS/SATA controller that provides additional RAID support
capabilities.
PCI Express Adapter
3. Grasp the riser card at the rear edge and lift to remove the riser-card
assembly. Place the riser-card assembly on a flat, static-protective surface.
4. Remove the expansion-slot cover from the slot that you intend to use.
Attention: PCI expansion-slot covers must be installed on all vacant slots.
This maintains the electronic emissions characteristics of the server and
ensures proper cooling of server components.
5. Route the adapter cables, if any, before you install the adapter. Route the
cables so that they are not on top of components or blocking the airflow from
the fans.
6. Touch the static-protective package that contains the adapter to any unpainted
metal surface on the server. Then, remove the adapter from the
static-protective package. Avoid touching the components and gold-edge
connectors on the adapter.
7. Set any jumpers or switches on the adapter as directed by the adapter
manufacturer.
8. Insert the adapter into the riser-card assembly, aligning the connector on the
adapter with the connector on the riser-card assembly. Press the adapter firmly
into the riser-card assembly. Make sure that the adapter snaps securely into
the riser-card assembly securely.
9. Insert the riser-card assembly into the riser-card connector on the system
board. Then, press down on the assembly. Make sure that the riser-card
assembly is fully seated in the riser-card connector on the system board.
Expansion
slot cover
Expansion
Riser-card
slot 1
assembly
Riser card
connector
Chapter 2. Installing optional devices
Adapter
support
bracket
29