IBM x3350 - System - 4192 User Manual page 60

v Event/Error Logs
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
46
IBM System x3350 Types 4192 and 4193: User's Guide
- User Account Settings
Select this choice to define user names and passwords for logging in to the
BMC to remotely control settings on the server.
- BMC Network Configuration
Select this choice to view the BMC MAC address, the DHCP IP address
and configure DHCP control.
- BMC System Event Log
Select this choice to view the BMC system event log, which contains
messages about system events, such as the event entry number,
timestamp, sensor type, sensor number, and event description. Select
Clear BMC SELs to clear the BMC system event log.
– High Precision Event Timer
Select this choice to enable or disable the high precision event timer.
Select this choice to view and clear the System Event/Error Log and the Remote
Supervisor Adapter II event/error log.
– System Event/Error Log
Select this choice to view the events and errors that were generated during
POST and by the system management interface (SMI) handler. The most
recent event is displayed first. Use the arrow keys to move among pages in
the log. Select Clear System Logs to clear the system event/error log.
– RSA II Event/Error Log
This choice is available only if an optional Remote Supervisor Adapter II
SlimLine is installed.
Select this choice to view the error messages in the Remote Supervisor
Adapter II event/error log. Use the arrow keys to move among pages in the
log. Select Clear RSA II logs to clear the Remote Supervisor Adapter II
event/error log.
The Remote Supervisor Adapter II event/error log contains all event and error
messages that have been generated during POST, by the system interface
handler, and by the system service processor. The most recent event or error
is displayed first.
Important: If the system-error LED on the front of the server is lit but there
are no other error indications, clear the Remote Supervisor Adapter II
event/error log. This log does not clear itself, and if it begins to fill up, the
system-error LED will be lit.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Select this choice to exit from the Configuration/Setup Utility program. If you have
not saved the changes that you have made in the settings, you are asked
whether you want to save the changes or exit without saving them.