IBM x3350 - System - 4192 User Manual page 51

5. At a downward angle, slip the back end of the adapter under the tab on the rear
mounting bracket, aligning the holes in the adapter with the posts on the rear
mounting bracket. Rotate the connector end of the adapter down into the front
mounting bracket, aligning the holes in the adapter with the posts on the front
mounting bracket.
6. Press the Remote Supervisor Adapter II SlimLine firmly into the connector and
make sure that all tabs on both mounting brackets secure the adapter in place.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
7. If you removed the riser-card assembly, install it in slot 2 on the system board.
Make sure that the riser-card assembly is fully seated in the riser-card
connector on the system board.
See the documentation that comes with the Remote Supervisor Adapter II SlimLine
for information about installing the firmware and configuring the adapter. Create a
backup copy of the configuration so that you can restore the configuration if you
have to replace the adapter in the future.
Note: When you start the server for the first time after you install a Remote
Supervisor Adapter II SlimLine, the start-up process will take several minutes
longer than a typical startup.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 38.
Chapter 2. Installing optional devices
37