IBM x3350 - System - 4192 User Manual page 49

SATA backplate
5. Lift the backplate out of the server.
6. Disconnect the power cable .
7. Install the SAS/SATA controller.
a. Grasp the edges of the SAS/SATA controller:
Notches
Mini-SAS/SATA
controller
b. Gently insert the controller into the SAS/SATA controller connector on the
system board (see "System-board internal connectors" on page 16 for the
location of the connector) while you align the holes in the controller with
the two plastic alignment pins on the system board.
c. Press the controller firmly onto the alignment pins until it clicks into place.
Make sure that the top of each alignment pin has expanded to hold the
controller securely in place.
d. Push the controller toward the right of the server, fully into the connector,
until the side tabs on the connector rest in the side notches of the
controller .
8. Install the SATA RAID backplate:
a. Connect the power cable to the backplate.
b. Slide the connector on the right side of the backplate under the top edge
on the rear of drive cage; then, slide the backplate into the card guides,
making sure that any nearby wires or cables are not trapped or pinched.
SATA cables
Tab
Chapter 2. Installing optional devices
35