Table of Contents
Advertisement
Solutions to Common Problems
SURFACE BURNERS DO NOT LIGHT
Surface Control knob has not been completely turned to LtTE. Push in and turn the
Surface Control knob to LITE until burner ignites and then turn control knob to desired
flame size.
Be sure gas supply valve is open.
Burner ports are clogged. Clean burners. See Cleaning
the Burner Grates, Burner
Caps,Burner
Heads in General Care & Cleaning section. With the burner off, clean
ports with a small-gauge wire or needle.
Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is
securely plugged into the outlet.
Electrical power outage (electric ignition models only). Burners can be lit manually.
See Setting Surface Controls in this Use and Care Guide.
BURNER FLAMEONLYLIGHTS HALFWAYAROUNDBURNER
IIIIIIIIIIIIIIIIIIIIII
• Burnerportsareclogged.
Withthe burneroff,
clean ports byusing asmall-gaugewire
orneedle.
• Moisture is present after cleaning. Lightly fan the flame and allow burner to operate
until flame is full. Dry the burners thoroughly following instructions in the General
Cleaning section.
BURNER FLAMEIS ORANGE
Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
In coastal areas, a slightly orange flame is unavoidable due to salt air.
Advertisement
Table of Contents
