Safety IMPORTANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions This is the safety alert symbol.
Safety SAFETY PRECAUTIONS WARNING WARNING WARNING WARNING WARNING • Read all instructions before using the appliance. • Improper installation, adjustment, alteration, service, or maintenance can cause personal injury or property damage. Refer to these instructions and the accompanying Use & Care Manual. For assistance or additional information, consult a qualified installer, service agency, manufacturer (dealer), or the gas supplier.
Page 4
• Installation of this appliance must be performed by a qualified installer, service agency or the gas supplier. Contact the nearest Electrolux Authorized Servicer, call 1-877-435-3287, or contact us on the internet at www.electroluxusa.com.
Finding Information TABLE OF CONTENTS Safety ..............2 Definitions ............2 Important Safety Instructions ....... 2 Safety Precautions ..........3 Finding Information ..........5 Please Read And Save This Guide ....5 Questions? ............5 Table Of Contents ..........6 Preparing for Installation ........
The back edge of the cooktop must remain a minimum of 2 1/2" (64mm) from any combustible backsplash material. This will require special cabinet and countertop dimensions. Installations with less than 2 1/2” from the rear of the cooktop to a combustible backsplash must use Electrolux Backsplash models ACCBG096S1 (for E36GC76EPS) or ACCBG0948S1 (for E48GC76EPS).
Page 8
Plan the installation so that the electrical connection, gas shut-off valve, and pressure regulator are accessible from the front of the cabinet and so that all of the minimum required dimensions are provided. E36GC76EPS: 42" (1067mm) Recommended Dimensions apply to both Figure 1 36" (914mm) Minimum E36GC76EPS: 36”...
Page 9
Preparing for Installation Base Cabinet Preparation Provide an opening in the countertop Top View as shown (see Figures 2, 3, 4, 5 and 6). Position the cutout so that minimum clearances are met. Countertop Preparation Figure 2 Figure 3 Countertop Cut-out Dimensions (when Cooktop is to be installed with Downdraft Vent Hood 36”...
Page 10
Preparing for Installation Overall Dimensions - Side Views Clearance to Combustible Rear Wall Figure 5 Overall Dimensions Cutout Dimensions Clearance to Combustible Rear Wall Dimensions Cooktop Model E48GC76EPS 48” Min. 48” 46” 48” Figure 6 E36GC76EPS 36” Min. 36” 34¾” 36”...
Making the Gas/Electric Connection REQUIREMENTS WARNING WARNING WARNING WARNING WARNING • If the gas or electric service provided does not meet the product specifications, do not proceed with the installation. Call the selling dealer, the gas supplier, or a licensed electrical or plumbing contractor. •...
Making the Gas/Electric Connection LIQUIFIED PETROLEUM (PROPANE) GAS CONVERSION This appliance can be used with Natural Gas and Propane Gas. It is shipped from the factory for use with natural gas. A kit for converting to LP gas is supplied with your cooktop. The kit is marked “FOR LP/PROPANE GAS CONVERSION”.
Page 13
Making the Gas/Electric Connection Electrical Supply Requirements The correct voltage, frequency and amperage must be supplied to the appliance from an isolated, grounded circuit which is protected by a properly sized circuit breaker or time-delay fuse. The cooktop must be connected to the power supply with copper wire only. The use of aluminum wire may result in unsatisfactory connections.
Installation INSTALLING THE COOKTOP Place and center the cooktop within the cutout. Secure the cooktop to the countertop utilizing the two (2) 1/4-20 bolts provided. Do not overtighten the screws. IMPOR IMPOR IMPORT T T T T ANT IMPOR IMPOR Do not use a hardening compound or caulking to permanently seal the cooktop into place, as the unit must be readily removable for service.
Installation INSTALLING THE BURNER COMPONENTS WARNING WARNING WARNING WARNING WARNING Never attempt to operate the cooktop with any of the burner rings, burner caps or burner grate components removed. Burner Components Remove the brass burner rings, porcelain burner caps, and porcelain grates from their shipping packages.
Installation MAKING THE ELECTRICAL CONNECTION WARNING WARNING WARNING WARNING WARNING • Ensure that the power supply is disconnected before proceeding. • Verify that the power supply matches the ratings found on the appliance data plate before proceeding. • The complete appliance must be properly grounded at all times when electrical power is applied.
Operation VERIFYING THE OPERATION WARNING WARNING WARNING WARNING WARNING • If the cooktop fails to operate properly, ensure that the electrical power supply and gas supply are turned on and that all installation steps have been carefully followed. Call a qualified service technician if the cooktop still does not operate properly.
Page 19
Operation Turn on the main gas supply to the cooktop by opening the gas shut-off valve. Test each burner separately by pressing and turning one control knob at a time counterclockwise to the “LITE/HI” position. All ignitors will spark simultaneously. (It will take approximately four seconds for ignition to occur, at which time all igniters will stop sparking.