Solutions To Common Problems; Entire Cooktop Does Not Operate; Surface Element Does Not Heat; Surface Element Too Hot Or Not Hot Enough - Electrolux EW36EC55GS1 Use & Care Manual

22

Solutions to Common Problems

IMPOR IMPORT T T T T ANT IMPOR IMPOR IMPOR
Before calling for service, review the following problems first. It may save you both time and
expense. This list includes common experiences that are not the result of defective
workmanship or material in your cooktop.

ENTIRE COOKTOP DOES NOT OPERATE

•
House fuse has blown or circuit breaker has tripped. Check/reset breaker or replace
fuse. If the problem is a circuit overload, have this situation corrected by a qualified
electrician.
•
Service wiring not complete. Contact installation agent or dealer.
•
Power outage. Check house lights to be sure. Call local electric company.

SURFACE ELEMENT DOES NOT HEAT

•
No power to appliance. Check/reset breaker or replace fuse. If the problem is a circuit
overload, or improper connection of the armored cable supplied with the appliance,
have this situation corrected by a qualified electrician.
•
Too low heat setting. Turn control to a slightly higher setting until element comes on.
•
Incorrect control is ON. Be sure to use correct control for the element needed.

SURFACE ELEMENT TOO HOT OR NOT HOT ENOUGH

•
Incorrect control setting. Raise or lower setting until proper amount of heat is obtained.
Dial markings are an indicator of relative heat settings and will vary slightly.
•
Lightweight or warped pans being used. Use only flat, evenly balanced, medium or
heavyweight cookware.
•
Voltage is incorrect. Be sure appliance is properly connected to the specified power
source.
•
Use only flat bottom, evenly balanced, medium or heavyweight cookware. Pans having
a flat bottom heat better than warped pans. Cookware material affects heating. Heavy
and medium weight pans heat evenly. Because lightweight pans heat unevenly, foods
may burn easily.
ANT ANT ANT ANT