Feed Guide Mechanism (Home Position Adjustment: X ) - Brother BAS-311E Service Manual

Chapter 3. Assembly

12. Feed guide mechanism (Home position adjustment: X )

311E, 311EL, and 326E
q
i
u
y
!1
o
!3
!2
5. Connect the programmer !2 to the operation panel !3 .
6. Plug the cord into the wall socket, and turn on the power of the machine.
7. Step on the foot switch to lower the H-position standard plate ! 1 .
8. Press the P key on the programmer !2 .
9. Attach the needle !4 .
10.Turn the pulley to bring the needle !4 close to the H-position standard plate !1 .
11.Press the jog key ( vu ) to adjust the work clamp arm !5 until its X-direction motion is parallel to the X-reference line
of the H-position standard plate ! 1 . Securely tighten the screws ! 6 .
46
r
e
t
w
!0
P key
BAS-311E.311EL.326E.326EL
1. Secure the large shuttle hook cover q with the two
shoulder screws w.
2. Secure the needle sub plate e with the screw r.
3. Remove the presser foot t.
4. Remove the screws u, tlat screws o and the work
clamp guide brackets A y, B i and replace the work
clamp !0 with the H-position standard plate !1 .
Note: Securely attach the H-position standard plate !1
using the work clamp guide brackets A y, B i
and the flat screws o.
!4
Parallel
X-reference
line
!5
!6
!1