Chapter 3. Assembly
i
5. Temporarily attach the work clamp Arm !2 to the Y-feed bracket i using the bolts and washers.
6. Temporarily attach the X-feed shaft support !3 to the Y-driving shaft e using the bolts and washers.
7. Pass the X-feed shaft !4 through the X-feed shaft support !3 and the work clamp Arm !2 , and secure the X-feed shaft
support !3 and the X-feed shaft !4 using the set screws.
8. Move the work clamp Arm ! 2 left and right to make sure that there is no inclination in X-feed shaft ! 4 . Then securely
tighten the bolts of Y-driving shaft e and the X-feed shaft support ! 3 .
9. Remove the set screw of the slider support shaft !5 from the front of the work clamp Arm !2 .
38
!5
!2
BAS-311E.311EL.326E.326EL
e
!3
!4