Brother BAS-311E Service Manual page 91

SW No.
A-5
After sewing is completed, work clamp does not automatically rise (only in split mode).
A-6 Clamping force output is produced (Inner clamping device available as an option).
Single-pedal operation using the starting switch; when the starting switch is pressed, the work clamp
A-7
A-8
DIP switch B
SW No.
B-1
B-2
B-3
B-4
B-5
When a fiber-type thread breakage detector device is used, detection precision is changed from 5 to 10.
B-6 Fiber-type thread breakage detector device is ON, and DIP switch A-8 is ON (available as an option)
B-7
B-8
lowers, and when it is released, sewing starts.
Thread breakage detector device is activated (available as an option).
Single split mode activated
Thread is not trimmed after an emergency stop.
Needle cooler output is produced. (available as an option).
When a rotating-type thread breakage detector device is used,
detection precision is changed from 8 to 14.
When using a 3-stage pedal
Feeding speed is switched to high speed.
BAS-311E.311EL.326E.326EL
Chapter 6 Power supply and electrical parts adjustment
When ON
When ON
----------------
83