Usb Memory (Usb Memory Selection) - Kyocera FS-C5350DN Advanced Operation Manual

USB Memory
/
/00:Folder 1
/00:Folder 1
/00:Folder 2
/.../00:Folder 2
/.../00:Folder 2
?
Using the Operation Panel

USB Memory (USB memory selection)

This specifies the settings for removing the USB memory and printing
USB memory content. The USB Memory menu automatically appears
when you install the USB memory.
IMPORTANT This message is displayed only when the USB host
block is not set.
The options available in USB Memory are as follows:
• Print File (Printing a file)
• Copies (Number of copies)
• Paper Source (Selecting the paper feed source)
• Remove Device (Removing the USB memory)
• Print File List (Printing a list of the files on a USB memory)
1
2
>
Print File (Printing a file)
You can use this to specify printing for files in the USB memory.
1
2
3
4
00:File 3
5
00:File 3
Press [MENU].
Press or repeatedly until USB Memory > appears.
Note that menus shown in the list may vary depending on which
optional units installed in the printer.
Press while USB Memory > is displayed.
>Print File appears. In other displays, press
until the map appears.
Press [OK]. A question mark (?) appears.
Press [OK] again. The folder or file appears.
(For example : Folder 1)
Each time you press or
succession.
To view lower-level folders or files, press
(For example : Folder 2)
To view folders or files on still lower levels, press
(For example : File 3)
IMPORTANT The Print File menu option is only displayed
when there is a PDF, TIFF, JPEG or XPS file in the USB memory.
Note also that up to 3 levels of folders or files are displayed. It
might take some time before the folder or file name appears,
depending on the size of the USB memory or the number of files.
You can move between the folder levels by pressing
and .
Press [OK]. A question mark (?) appears.
(For example : File 3)
or
, the next folder or file appears in
.
.
repeatedly
and or
2-17