Download  Print this page

Kenmore 8787 - Elite HE3 7.0 cu. Ft. Electric Dryer Use And Care Manual page 13

Use and care guide
Hide thumbs

Advertisement

Table of Contents
When connecting to the terminal block, place the hooked end of
the wire under the screw of the terminal block (hook facing right),
squeeze hooked end together and tighten screw, as shown.
1=
2.
Loosen or remove center silver-colored
terminal block screw.
Place the hooked end of the neutral wire (white or center wire)
of direct wire cable under the center screw of terminal block
(hook facing right). Squeeze hooked end together. Tighten
screw.
Optional 3-wire connection
Use for direct wire or power supply cord where local codes
do not permit connecting cabinet-ground
conductor to
neutral wire.
1. Remove center silver-colored
terminal block screw.
2. Remove neutral ground wire from external ground conductor
screw. Connect neutral ground wire and the neutral wire
(white or center wire) of power supply cord/cable
under
center, silver-colored
terminal block screw. Tighten screw.
D
A. External ground conductor screw
B.Neutral ground wire
C. Center silver-colored terminal block screw
D. Neutral wire (white or center wire)
EL_" (1.9 cm) UL Iisted strain relief
Place the hooked ends of the other direct wire cable wires
under the outer terminal block screws (hooks facing right).
Squeeze hooked ends together. Tighten screws.
!! !!
4. Tighten strain relief screw.
5. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
6. You have completed your electrical connection.
Now go to
"Venting Requirements."
4=
5.
A. External ground conductor
screw
B. Center silver-colored
terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
EL _" (!.9 cm) UL ilsted strain relief
F Grounding path determined
by a qualified electrician
Connect the other wires to outer terminal block screws.
Tighten screws.
!! !!
----=
Tighten strain relief screws.
Connect a separate copper ground wire from the external
ground conductor screw to an adequate ground.
Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down
screw.
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

He3 110.8787 seriesHe3 110.8789 series