Attaching 802.11B Interface Unit Type F - Ricoh AP610N - Aficio B/W Laser Printer Setup Manual

Attaching 802.11b Interface Unit Type F

R CAUTION:
• Do not touch the inside of the
controller board compartment.
Doing so may cause a machine
malfunction or a burn.
Important
❒ Before touching the 802.11b inter-
face unit, touch something metal to
discharge any static electricity.
Static electricity can damage the
802.11b interface unit.
❒ Do not subject the 802.11b interface
unit to physical shocks.
A
Check the package contains the
following:
❖ 802.11b Interface Unit Type F
• Interface Unit
• Card
Attaching 802.11b Interface Unit Type F
• Antenna Cap
B
Turn off the power of the printer,
and then unplug the printer's
power cable and the interface ca-
ble.
C
If the duplex unit is attached,
push down the lever on right side
( ) and pull out the duplex unit
until it stops ( ).
If the duplex unit is not attached,
go to the following steps.
ZKDP410J
ZKDX230J
ZKDP900J
3
ZKGX320E
43