Loading Paper - Ricoh AP610N - Aficio B/W Laser Printer Setup Manual

Setting Up

Loading Paper

The following describes how to load pa-
per into the standard paper tray (Tray 1).
R CAUTION:
• Do not pull out the paper tray
2
forcefully. If you do, the tray
might fall and cause an injury.
Important
❒ To avoid paper jams, make sure
paper is not stacked above the lim-
it mark inside the tray. Misfeeds
might occur.
❒ Do not mix different types of paper
in a single paper tray.
A
Lift the paper tray slightly, and
then pull it out until it stops.
Note
❒ Do not touch the three white pins
on the left front of the printer.
B
Lift the front side of the tray, and
then pull it out of the printer.
24
C
Load the new paper into paper
tray with print side up.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
❒ Confirm that the paper fits un-
der the rear guides.
Note
❒ When loading paper other than
A4L(long-edged feed) or 8
11L(long-edged feed), adjust
the paper size dial to match the
size and feed direction of the
paper in the paper tray.
AGN029S
❒ When loading paper other than
A4K(short-edged feed) or 8
× 11K(short-edged feed), you
should extend the tray.
ZKGY140E
ZKGY130E
×
1
/
2
AGN033S
1
/
2