WELLTECH WILLGATE26XX - RELEASE NOTE 2 V106C User Manual

1. Network fail to start when the leading 0 is not stripped (e.g. 192.168.018.018)
2. Fixed the DSP download failure occasionally during boot up.
1. Added a timer to delay answer the VOIP incoming call to FXO when PSTN line doesn't support
polarity reverse.
2. When PABX mode is enabled and the FXS line is also registered, FXS do the routing based on
the FXO prefix routing table. (2644 only)
3. Increased voice volume for FXS and FXO. It is recommended to change the voice volume as
follows at default setting.
FXO: remove receive volume -3 db, local receive volume: 0 db
FXS: remove receive volume 0 db, local receive volume: - 3 or -6 db
WELLTECH WEB Site:http://www.welltech.com
Firmware Download:
User Manual: http://www.welltech.com/support/26xx.htm
http://www.welltech.com/support/26xx.htm
H . W . S . W .