Advertisement
WORKMAN PRO
Thnak you for your purchasing Minoura "
" truing stand.
This Workman Pro is a wheel truing stand for stan-
dard bicycle with unique Auto-Centering system that
allows you to do almost every procedure such as
building or adjusting your bicycle wheel without any
tool such as a wheel centering gauge basically.
The frame is foldable for your easy storage and trans-
portation.
Please read this instruction manual carefully before
use and we hope you grow up your skills of the bi-
cycle wheel.
A wheel truing stand is a utensil to measure the bal-
ance of the wheel. Do not use Workman Pro as a
display stand or an indoor bicycle trainer.
This Workman Pro has a special method, auto-cen-
tering system, so you can finish building or checking
a wheel with only this truing stand basically. But we
suggest you to use a wheel centering gauge for your
complete wheel adjustment.
Side
Shaking
Gauge
Vertical Shaking
Gauge Knob
Both right and left arms are connected so they will
move together at the same time. When you open or
close the arms, you should hold both arms with your
both hands.
U-shaped Gauge
Frame
Vertical Shaking
Gauge Plate
Gauge Stay
Advertisement
Table of Contents
Related Manuals for MINOURA WORKMAN PRO
Summary of Contents for MINOURA WORKMAN PRO
- Page 1 A wheel truing stand is a utensil to measure the bal- ance of the wheel. Do not use Workman Pro as a display stand or an indoor bicycle trainer. This Workman Pro has a special method, auto-cen- tering system, so you can finish building or checking a wheel with only this truing stand basically.
- Page 2 They have 0.1mm level scale on their own surfaces. to fix the gauge stay position. After you set the wheel on the Workman Pro, put the U-shaped frame close to the rim. And tighten the knob bolts to approach to the rim surface. Do NOT touch...
- Page 3 Left side Then you can fold the Workman Pro. Make sure that spoke tension is just a help. you do not pinch your finger in the frame or the stay. Also you should understand that the nipple is not al-...
- Page 4 Rotate the wheel slowly, and check the side shaking. And stick vinyl tapes to two spokes; one is the begin- ning amd one is in the ending of the side shaking. Make three groups of these spokes between the vinyl tales as below;...
Need help?
Do you have a question about the WORKMAN PRO and is the answer not in the manual?
Questions and answers