Marks & Spencer IDECT X2I TWIN Manual page 54

Color profile: Disabled
Composite Default screen
Using a multi-handset system
"I can't transfer Make sure the other handset is in range of the base unit.
a call."
Make sure you're dialling the correct number for the
other handset (1 to 4, or Ø for all registered handsets).
Batteries
"The handset's Before you first used the handset, you should have left it
on the base unit or charger pod for up to 15 hours to
batteries are
charge the batteries fully.
running low
within an
You may need to replace the batteries (see below).
hour or two."
Clean the battery charging contacts on the base unit
with a dry cloth.
Check the connections between the base unit and the
mains power socket.
"I try to You need to replace the batteries. To find out how to
recharge the obtain replacements, call
batteries, but I 9.00 am and 5.00 pm, Monday to Friday.
still get a
Dispose of used batteries safely — never burn them,
warning that
or put them where they could get punctured.
they are low."
ALWAYS use the batteries supplied with your
telephone — other batteries may burst, causing
damage.
PBX use
"The Recall You may need to change the recall signal length from
its default of 100 ms. Consult your PBX documentation
function doesn't
for help if necessary. To change the recall setting, use
seem to work."
the Advanced set > > > > > > > Recall Time menu and change to
Medium(250ms)or long(600ms).
Help Line:
0845 671 0665 (Local Call rate)
Troubleshooting
0845 6 71 0665, between
51