Install The Drum Unit; Load Paper - Brother HL 1240 - B/W Laser Printer Service Manual

3.2 For Windows
If you do not have a CD-ROM drive, setup the printer following the steps below, then install the
printer driver from the floppy disk.
3.2.1

Install the drum unit

(1) Open the front cover.
(2) Unpack the drum unit assembly and rock
it from side to side 5 or 6 times to
distribute the toner evenly inside the
cartridge. (Fig. 2-8)
(3) Install the drum unit into the printer until it snaps into place and close the front cover.
3.2.2

Load paper

(1) Pull the paper cassette completely out of the printer.
(2) Slide the paper guides to the paper size
you want until they snap into a slot. (Fig.
2-9)
(3) Load paper into the paper cassette.
Check that paper is flat placed. (Fig. 2-
10) Paper should be loaded up to the
lines on the sliding guide.
(4) Re-install the paper cassette into the
printer.
3.2.3 Print a test page
(1) Check that the power switch is off.
(2) Connect the AC power cord to the printer.
(3) Plug the AC power cord into an AC outlet,
then turn on the power switch. (Fig. 2-11)
®
Users with No CD-ROM Drive
CHAPTER 2 INSTALLATION AND BASIC OPERATION
2-5
Fig. 2-8
Fig. 2-9
Fig. 2-10
AC power cord
Fig. 2-11