Brother HL 1240 - B/W Laser Printer Service Manual page 82

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
(12) Remove the one M3x10 Taptite screw securing the halogen lamp connector plate at the
drive unit side of the fixing unit frame and then loosen the M3x6 screw at the other side.
(13) Lift the right hand end of the heat roller and remove the halogen heater lamp from the heat
roller.
Screw, cup M3x6
Heat roller
!
CAUTION:
Never touch the surface of the halogen heater lamp.
When securing the screw to assemble the halogen lamp connector plate, ensure to use the
plastic jig as shown in the figure below to avoid the edge of the halogen heater lamp
damaged;
Halogen heater lamp
NOTE:
When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater
lamp is correct referring to the figure above.
Halogen heater lamp
Halogen lamp
connector plate
Halogen heater lamp
Heat roller
Fig. 4-34
Taptite, pan M3x10
Fig. 4-35
4-20
PR99156
Colored side
115V: Yellow
230V: Purple
Taptite, pan M3x10
Halogen lamp
connector plate
Plastic jig