Access Options - HP AB500A - Integrated Lights-Out Advanced User Manual

Access options

iLO 2 enables you to modify iLO 2 access, including connection idle time, iLO 2 functionality, iLO 2
RBSU, login requirements, CLI parameters, minimum password length, and server name. Settings on the
Access Options page apply to all iLO 2 users. You must have the Configure iLO 2 Settings privilege to
modify settings on this page.
To view or modify iLO 2 access, click Administration>Access>Options and click Apply to save any
updated information. You must restart iLO 2 before your updates take effect. If any changes enable or
disable Lights-Out functionality, click Apply to terminate your browser connection and restart iLO 2. You
must wait at least 30 seconds before attempting to reestablish a connection.
The Options tab includes the following:
Parameter
Idle Connection
Timeout (minutes)
Lights-Out
Functionality
Default value Descriptions
30 minutes This setting specifies the interval of user inactivity, in minutes,
before the web server and Remote Console session
automatically terminate. The following settings are valid: 15,
30, 60, 120 minutes, or 0 (infinite). The infinite timeout value
does not log out inactive users.
Enabled This setting enables connection to iLO 2. If disabled, all
connections to iLO 2 are prevented.
The iLO 2 10/100 network and communications with
operating system drivers are turned off if Lights-Out
functionality is disabled. The iLO 2 Diagnostic Port for an HP
ProLiant BL p Class server is also disabled.
If iLO 2 functionality is disabled (including the iLO 2
Diagnostic Port), you must use the server's Security Override
Switch to enable iLO 2. See your server documentation to
locate the Security Override Switch and set it to override.
Power up the server and use the iLO 2 RBSU to set Lights-Out
Functionality to Enabled.
Configuring iLO 2 39