Stopping File Transfers; Closing The Transfer Tool - Texas Instruments TINSPIRE Manual Book

• To transfer files to all connected TI-Nspire™ handhelds, select
Connected Handhelds (top level).
3. In the Transfer Tool window, click
The Transfer Tool window switches to the
transfer information.
• The progress bar disappears when a transfer is complete.
• During a transfer, the Transfer Tool indicates which handhelds are
connected and successfully received files.
• If a handheld disconnects and then reconnects during a transfer,
the Transfer Tool indicates the status of completed transfers, and
resumes transferring other files as necessary.

Stopping file transfers

You can stop a file transfer at any time.
To stop a file transfer, complete the following steps:
1. In the Tranfer Tool, click
The Confirm dialog box opens.
2. Click to confirm.
Yes
The Transfer Tool stops transferring and switches back to the
tab.
• If a connected handheld has already received files, those files
remain on the handhelds.
• Files remain in the
until you remove them by selecting the files and clicking
Selected

Closing the Transfer Tool

When you have completed transferring files and folders, close the
Transfer Tool.
To close the Transfer Tool, click Close.
• You cannot close the Transfer Tool if a transfer is active.
Stop Transfer
Setup
.
Start Transfer
Status
.
tab until you close the Transfer Tool, or
Using the Transfer Tool
.
tab and displays the
Setup
Remove
81