Setting Up Triggering - Texas Instruments TINSPIRE Manual Book

Follow these steps after you collected your data with the TI-Nspire™ Lab
Cradle.
1. Open the Vernier DataQuest™ application.
2. Attach the TI-Nspire™ Lab Cradle to the handheld or computer.
3. Shortly, the Remote Data Detected message box displays: "The
connected device has remote data. Do you wish to import or discard
the data?"
4. Select Import.
The data is now in the Vernier DataQuest™ application.

Setting up Triggering

Data collection can be set to start based on a specific sensor reading. This
functionality is only available when using the TI-Nspire™ Lab Cradle.
Setting up the sensor for triggering
Set the sensor and the threshold type for the system to use when
analyzing when the trigger is reached so it can start the data collection.
You must have the TI-Nspire™ Lab Cradle and sensor connected to
perform this procedure.
1. Select
Experiment > Advanced Set up > Triggering > Set Up
The Configure Trigger dialog box is opened.
774 Data Collection and Analysis
.