Using Library Objects - Texas Instruments TINSPIRE Manual Book

A library object does not appear in the Catalog, but you can
Private
access it by typing its name. Private objects serve well as building blocks
that perform basic, low-level tasks. Typically, private library objects are
called upon by the public functions and programs.
A library object appears in the Catalog's library tab after you
Public
refresh the libraries. You can access a public library object through the
Catalog or by typing its name.
Macintosh® only: In version 1.4 of the software, a library document
name cannot contain extended characters, such as Ö, á, or ñ.
Note: In library programs and functions defined as public, a comment
line (©) immediately following the
displayed as help in the Catalog. You could, for example, show a syntax
reminder there.
Using short and long names
Anytime you are in the same problem where an object is defined, you
can access it by entering its short name (the name given in the object's
command). This is the case for all defined objects, including
Define
private, public, and non-library objects.
You can access a library object from any document by typing the object's
long name. A long name consists of the name of the object's library
document followed by a backslash "\" followed by the name of the
object. For example, the long name of the object defined as
library document
handheld, press
Note: If you cannot remember the exact name or the order of arguments
required for a private library object, you can open the library document
or use the Program Editor to view the object. You also can use
to view a list of objects in a library.
getVarInfo

Using library objects

Before using a library variable, function, or program, make sure that
these steps have been followed:
• The object has been defined with the
command specifies either the LibPriv or LibPub attribute.
• The object resides in the first problem of a library document. The
document must reside in the designated library folder and must meet
the naming requirements.
• If you defined the object using the Program Editor, it has been stored
using
Check Syntax & Store
is
lib1 lib1\func1
g p
.
or
Prgm Func
. To type the "\" character on the
Define
from the Program Editor menu.
line is automatically
func1
command, and the
Libraries
in the
667