Table of Contents
Advertisement
Switch Installation
This chapter describes how to install and connect a Catalyst 3750-X or a 3560-X switch. It also includes
planning and cabling considerations for stacking switches (only Catalyst 3750-X switches). Read the
topics and perform the procedures in this order:
•
•
•
•
•
•
•
•
•
For initial switch setup, how to assign the switch IP address, and for powering information, see the
switch getting started guide on Cisco.com.
Preparing for Installation
•
•
•
Safety Warnings
This section includes the basic installation caution and warning statements. Translations of the warning
statements appear in the Regulatory Compliance and Safety Information for the Catalyst 3750-X
and 3560-X Switch document available at Cisco.com. Read this section before you start the installation
procedure.
OL-19593-02
Preparing for Installation, page 2-1
Planning a Switch Data Stack (Catalyst 3750-X Switches), page 2-4
Planning a StackPower Stack (Catalyst 3750-X Switches), page 2-8
Installing the Switch, page 2-14
Connecting to the StackWise Ports (Catalyst 3750-X Switches), page 2-20
Installing a Network Module in the Switch, page 2-22
Installing SFP and SFP+ Modules, page 2-24
Connecting Devices to the Ethernet Ports, page 2-26
Where to Go Next, page 2-29
Safety Warnings, page 2-1
Installation Guidelines, page 2-3
Tools and Equipment, page 2-4
C H A P T E R
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
2
2-1
Advertisement
Table of Contents
