Installing The Cisco Microsoft Windows Usb Device Driver; Installing The Cisco Microsoft Windows Xp Usb Driver; Installing The Cisco Microsoft Windows 2000 Usb Driver; Installing The Cisco Microsoft Windows Vista And Windows 7 Usb Driver - Cisco WS-C3560X-48PF-L Hardware Installation Manual

Appendix C Configuring the Switch with the CLI-Based Setup Program
Figure C-1
Connect a USB cable to the PC USB port. Connect the other end of the cable to the switch mini-B
Step 2
(5-pin-connector) USB console port. See
Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC
Step 3
application such as HyperTerminal or ProcommPlus, makes communication between the switch and
your PC or terminal possible.
Step 4 Configure the baud rate and character format of the PC or terminal to match the console port default
characteristics:
•
•
•
•
•
Connect power to the switch as described in
Step 5
The PC or terminal displays the bootloader sequence. Press Enter to display the setup prompt. Follow
Step 6
the steps in the

Installing the Cisco Microsoft Windows USB Device Driver

A USB device driver must be installed the first time a Microsoft Windows-based PC is connected to the
USB console port on the switch.
•
•
•
OL-19593-02
Connecting the USB Console Cable to the Catalyst 3750-X or 3560-X Switch
M O D E
1
2
9600 baud
8 data bits
1 stop bit
No parity
None (flow control)
"Configuring the Setup Program" section on page

Installing the Cisco Microsoft Windows XP USB Driver

Installing the Cisco Microsoft Windows 2000 USB Driver

Installing the Cisco Microsoft Windows Vista and Windows 7 USB Driver

C O N S O
L E
S Y S T
X P S
E N S T A T
S P E E D
S -P W R
M A S T
S T A C K
3
4
5
6
7
8
9
Figure C-1.
Chapter 3, "Power Supply and Fan Module
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
Accessing the CLI
D U P L X
P o E
1 0
1 1 1 2
C-6.
Installation.".
C-3