Cisco SRST - 881 EN Security Router Wireless Manual page 52

CISCO-SRST-MIB Object Groups
Table 1-6 SRST MIB Object Groups and Descriptions (continued)
MIB Group
Cisco SRST SNMP MIB Release 3.4 Guide
1-38
MIB Object
csrstAliasTag
csrstAliasNumPattern
csrstAliasAltNumber
csrstAliasPreference
csrstAliasHuntStopEnabled
csrstAccessCodeType
csrstAccessCode
csrstAccessCodeDIDEnable
d
Max
Access Description
read-only A unique sequence number that indicates a particular
alias pattern configured on this SRST router.
read-only This object indicates the pattern to match the incoming
telephone number. It may include wildcards.
read-only This object indicates the alternate telephone phone
number to route incoming calls to match the number
pattern. This has to be a valid extension for an IP phone
actively registered on the SRST router.
read-only This object indicates the preference value of the
associated dial-peer. A value of 0 has the highest
preference.
read-only This object specifies that if hunt stop is enabled, after
the caller tried the alternate number according to the
alias pattern, it will stop call hunting. If hunt stop is
disabled, it will rollover to another directory number if
available.
read-only This object indicates the type of trunk line to which the
access-code is applied to.
fxo (1),
em (2),
bri (3),
pri (4)
The type of trunk lines can be fxo, e&m, bri, and pri.
fxo - Enables a foreign exchange office (FXO)
interface.
em - Enables an analog ear and mouth (E&M)
interface.
bri - Enables a BRI interface.
pri - Enables a PRI interface.
read-only This object indicates the access-code to be applied to
the corresponding trunk line by creating dial-peers.
read-only This object indicates the direct-inward- dial on a POTS
dial-peer is enabled or disabled.
Chapter 1 Cisco SRST SNMP MIB Support
OL-7959-01