Seat Adjustment Lever; Bypass Linkages - Dixon ZTR34/968999564 Operator's Manual

2. Seat adjustment lever

The seat can be adjusted lengthways. When making
adjustments, sit on the seat. Slide the lever to the side
and maneuver seat to appropriate placement and
release lever.

3. Bypass Linkages

When pushing or pulling the mower, be sure to engage
the IZT (Integrated Zeroturn Transaxle) bypass
linkages.
•
Always turn off engine before engaging or
disengaging the hydro release. Never
attempt to adjust the bypass linkages with the
engine running.
•
The hydro release valves are located below
the seat, on the front side of the hydro
pumps.
•
Raise the deck into the highest cutting
position.
•
Lift the seat frame assembly to access the
release valves.
•
Use a 5 / " wrench to rotate bolt counter-
8
clockwise two full turns to disengage pump.
•
Repeat the procedure for the opposite pump.
•
To engage, rotate each pump bolt clockwise
until the bolt is snug. Do not overtighten the
release valve or damage to the hydro pump
could occur.
IMPORTANT INFORMATION
Before pushing or towing tractor,
transmission must be unlocked and park
brake released. The tractor should never
be pulled at more than 2 miles per hour
(3.2 km/h) or for distances over ¼ mile
(.402 km). Trailer the unit for distances
over ¼ mile.
CONTROLS
Seat adjustment
1
1. Left hydro gear
2. Release valve
Bypass linkages
2
8050-165
8050-767
19
-
English