Seat Adjustment Lever; Bypass Linkage - Dixon SPEEDZTR 44 965981001 Operator's Manual

Seat Adjustment Lever

The seat can be adjusted lengthways. Release
levers are located at the lower front right, or on the
right side—depending on model. When making
adjustments, sit on the seat. Slide the lever and
maneuver seat to appropriate placement and release
lever.

Bypass Linkage

Unlocking Transmission
When pushing or pulling the mower, engage the EZT
(Integrated Zeroturn Transaxle) bypass linkages. The
EZT bypass linkages are located on the rear of the
frame, below the rear engine guard.
1. Raise the deck into the highest cutting position.
2. Pull the EZT bypass linkages up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
3. To reengage the EZT's to drive, reverse the
above procedure.
Load the machine into truck or trailer by driving up
ramps in low gear. DO NOT LIFT! The machine is not
intended to be lifted by hand.
IMPORTANT INFORMATION
Before pushing or towing tractor, transmission
must be unlocked and park brake released.
The tractor should never be pulled at more
than 2 miles per hour (3.2 km/h) or for
distances over ! mile (.402 km). Trailer the
unit for distances over ! mile.
CONTROLS
Seat adjustment
Bypass linkage, EZT engaged
Bypass linkage, EZT locked in the bypass position
8050-165
8058-032
8058-032
-19
DIXON