Seat Adjustment Lever; Fuse; Tracking - Dixon ZTR SPEEDZTR 48SE Operator's Manual

Seat Adjustment Lever

The seat can be adjusted lengthways. When making
adjustments, the lever under the right side of the
seat is pulled up, after which the seat can be moved
backward or forward.
IMPORTANT INFORMATION
Seat should not be adjusted while unit is in
motion.

Fuse

The 20 amp primary fuse is located on the left
hand side of the machine. It is accessed by tilting
the seat forward. The fuse is a flat pin type used in
automobiles.

Tracking

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1. Tracking adjustments are made using the tracking
bolts. The tracking bolts act as limiting devices for
the motion control levers when in the full-forward
position.
2. For preliminary tracking adjustment, move unit
to an open, unobstructed area such as an empty
parking lot or open field.
3. Back the tracking bolts out until flush with nut.
4. Test operate unit by driving it at full throttle and
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on the
right hand side until the unit noticeably starts
drifting right.
5. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the left tracking bolt until unit
tracks straight
ContRols
Lengthways adjustment
Fuse
Tracking knob
8058-023
8058-234
8058-191
23