Disarming; Alarm Memory - DSC PC 4020 - V3.0 Manual

Quick Arm
When the Quick Arm feature is enabled, the system may be armed by
simply pressing [*][0] instead of your access code. Please note that pressing
[*][0] will only allow you to arm the system; to disarm, you must enter a
valid access code. Your system administrator will inform you if the Quick
Arm feature has been enabled on your system.

1.4 Disarming

Enter the premises through a designated exit/entry door. Entering the
premises through any door not designated as a point of entry will cause
an immediate alarm. As soon as the exit/entry door is opened, the keypad
sounder will beep and the entry delay will begin. The entry delay provides
a window of up to 255 seconds to disarm the system.
Go to the keypad and enter your access code. If an error is made entering
the code, press the [#] key and enter the code again. The Armed light will
turn off and the keypad buzzer will stop. A valid access code must be
entered before the entry delay time expires.
If an alarm occurred while the panel was armed, the "View Memory"
message will be on the display with the zone name for the zone that caused
the alarm. The display will keep those messages on for two minutes or
until the [#] key is pressed. The keypad will then return to it's idle state.
Disarming Another Partition
If you have a multi-partition access code, you can disarm other partitions
before entering them. To disarm another partition, enter your access code.
The keypad display will read:
(0) TO ARM
(Partition Label) R
Use the arrow (< >) keys to scroll to the partition you wish to disarm.
Remember that only partitions to which your access code is assigned will
be displayed. If the partition you have selected is armed, the letter "A"
will appear on the bottom right-hand corner of the display, as in the
following example:
(2) TO SELECT < >
(Partition Label) A
To disarm the partition, press the number in parentheses (in this case, [2])
or press the [*] key.

1.5 Alarm Memory

To view alarms that occurred while the system was armed, press [*] then
[3]. Alarms caused during the last armed period will be displayed. Press
[#] when you have finished viewing alarms to exit the alarm memory
mode.
NOTE: Tamper alarms will not be shown in alarm memory display.
6
< >