Change User Code Options; Access Code Label Options - DSC PC 4020 - V3.0 Manual

Once the code has been selected, the Program Code menu will be shown.
Reprogram the access code, code label or partition access using the steps
outlined in Section 2.1 "Program a New Code".

2.3 Change User Code Options

User code options determine which system features the code will be able
to access. Table 2-1 shows all of the available access code options. The
table also indicates which options are enabled by default for each type of
code.
To change the user options for a code from its default settings, perform
the following:
1. Enter [*][5] followed by a Master code.
2. Locate the code using one of the code searching methods (see Section
2.2). Press [*] to select.
3. Use the right arrow (>) key to scroll to the following display:
Select (5) < >
Edit User Opt's
Press [5] or [*].
4. Use the arrow (< >) keys to scroll through each option. Press [*] to
turn each option on (Y) or off (N).
5. When the desired options have been programmed, press [#].

2.4 Access Code Label Options

In Section 2.1, you learned how to program the access code label ("Program
User Name"). There are other options available when programming labels.
When programming the label, press the [*] key for the options menu. Use
the arrow (< >) keys to scroll through each option. Press the [*] key to
select.
The available options are:
• Clear Display: Selecting this option will clear the entire code label.
• Clear to End: This will clear the display from the character where
the cursor was located to the end of the display.
• Change Case: This will toggle the letter entry between uppercase
and lowercase letters.
• ASCII Entry: This is for entering uncommon characters. Use the
arrow (< >) keys to scroll through the available characters. Each
character will be displayed along with the corresponding 3-digit
ASCII number. If you know the character's 3-digit number, enter it.
Press the [*] key to enter the character into the code label. See
Appendix A at the back of this manual for a list of the available ASCII
characters.
12