Installing A Remote Supervisor Adapter Ii Slimline - IBM 7979B1U User Manual

5. Disconnect any cables from the adapter.
6. Carefully grasp the adapter by its top edge or upper corners, and pull the
7. If you have other optional devices to install or remove, do so now. Otherwise,

Installing a Remote Supervisor Adapter II SlimLine

An optional Remote Supervisor Adapter II SlimLine can be installed only in a
dedicated slot on the system board. See "System-board optional-device connectors"
on page 17 for the location of the connector. After the Remote Supervisor Adapter II
SlimLine is installed, the systems-management Ethernet port on the rear of the
server is active.
Note: Earlier versions of the Remote Supervisor Adapter II SlimLine might not work
in this server. See http://www.ibm.com/servers/eserver/serverproven/compat/us/ for
the supported Remote Supervisor Adapter II SlimLine.
adapter from the PCI slot.
go to "Completing the installation" on page 81.
Access holes
Chapter 2. Installing optional devices
Release tabs
43