Completing The Installation - IBM 7979B1U User Manual

User manual
Hide thumbs Also See for 7979B1U:
Table of Contents

Advertisement

3. Remove the cover (see "Removing the cover" on page 31).
4. Follow the instructions that come with the drive to set any jumpers or switches.
5. Attach the drive retention clip to the side of the drive.
6. Slide the drive into the CD/DVD drive bay until the drive clicks into place.
If you have other optional devices to install or remove, do so now. Otherwise, go to

"Completing the installation."

Completing the installation
To complete the installation, complete the following steps:
1. If you removed the PCI riser-card assembly, replace the riser-card assembly
2. If you removed any air baffles, replace the air baffles (see "Installing the
3. If you removed the server cover, place the cover-release latch in the open (up)
4. Install the server in a rack. See the Rack Installation Instructions that come with
Attention:
In a dc power environment, only trained service personnel other
than IBM service technicians are authorized to connect or disconnect power to
the dc power supply. See the documentation that comes with each dc power
supply.
Drive retention clip
Alignment pins
(see "Installing the riser-card assembly" on page 33).
microprocessor air baffle" on page 35 and "Installing the DIMM air baffle" on
page 37).
position. Insert the bottom tabs of the top cover into the matching slots in the
server chassis. Press down on the cover-release latch to lock the cover in
place.
the server for complete rack installation and removal instructions.
Cover-release
latch
Chapter 2. Installing optional devices
81

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents