IBM 7979B1U User Manual page 60

To install a Remote Supervisor Adapter II SlimLine, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover (see "Removing the cover" on page 31).
4. Remove the PCI riser-card assembly (see "Removing the riser-card assembly"
5. Turn the Remote Supervisor Adapter II SlimLine so that the keys on the
6. Slip the free end of the Remote Supervisor Adapter II SlimLine under the tab on
7. Replace the PCI riser-card assembly.
See the documentation that comes with the Remote Supervisor Adapter II SlimLine
for information about installing the firmware and configuring the adapter. Create a
backup copy of the configuration so that if you have to replace the adapter in the
future, you can restore the configuration.
If you have other optional devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 81.
44
System x3650 Type 7979: User's Guide
Connector
Retainer bracket
on page 28.
external cables (see "Turning off the server" on page 13).
Attention: In a dc power environment, only trained service personnel other
than IBM service technicians are authorized to connect or disconnect power to
the dc power supply. See the documentation that comes with each dc power
supply.
on page 32).
connector align correctly with the connector on the system board.
the retainer bracket, aligning the holes in the adapter with the posts on the
retainer bracket and latch bracket; then, press the adapter into the connector on
the system board and make sure that all tabs on the latch bracket secure the
adapter in place.
Remote Supervisor
Adapter II SlimLine
Latch bracket