Sorting; Ipv4 And Ipv6 Network Address Capabilities - Dell PowerEdge 180AS User Manual

• The Explorer only shows the target devices listed in its database, with
the name specified in the database. In other words, the Explorer does
not talk to the switch to obtain target device information.
• The Resync Wizard overwrites locally-defined target device names
only if the switch target device name has been changed from the
default value. Non-default target device names that are read from the
switch during a resynchronization override the locally-defined names.

Sorting

In certain displays, the software component displays a list of items with
columns of information about each item. If a column header contains an
arrow, you can sort the list by that column in ascending or descending order.
To sort a display by a column header, click the arrow in a column header. The
items in the list are sorted according to that column. An upward-pointing
arrow indicates the list is sorted by that column header in ascending order. A
downward-pointing arrow indicates the list is sorted by that column header in
descending order.

IPv4 and IPv6 Network Address Capabilities

The RCS software is compatible with systems using either of the currently
supported Internet Protocol Versions, IPv4 (default) or IPv6, or both the IPv4
and IPv6 modes simultaneously.
The IPv4 mode connection can be either a stateful (configuration and IP
addresses are provided by the server) or a stateless (the switch normally
receives the IP address and router address dynamically from the router) auto-
configuration. Switch firmware upgrades and emergency boot firmware
upgrades are supported for both TFTP and FTP servers while in IPv4 mode.
The IPv6 mode is a stateless, auto-configuration connection. While in IPv6
mode, switch firmware upgrades are only facilitated in FTP mode and
emergency boot firmware flash downloads cannot be performed. To perform a
flash download, you must temporarily connect to an IPv4 network with a
TFTP server.
Product Overview
5