Electrical Installation - Dacor ERV30 Installation Instructions Manual

Electrical Installation

WARNING
• ELECTRIC SHOCK HAZARD
raised vent power plug to the electrical outlet until
installation is complete.
• Failure to complete electrical connections properly
may result in an electric shock hazard or a damaged
or non-functional system. Follow the wiring diagrams
carefully to ensure a proper installation. Do not
change the factory wired terminal connections inside
the electrical access panel for the raised vent or the
blower.
• To avoid an electric shock hazard and to prevent
damage route all wiring away from hot surfaces.
ERV Raised Vent
Front View
10
Installation Instructions
- Do not connect the
Electrical access
panel
1. Run the wiring/conduit line used to supply power from
the raised vent to the blower parallel to the duct work.
2. Make sure the raised vent power plug is disconnected
from the electrical outlet.
3. Remove the cover from the raised vent electrical
access panel.
4. Connect the wiring/conduit to the blower according to
the wiring diagrams on this page, the facing page and
local codes and ordinances. Make sure all terminal
connections, including the factory wired connections,
are tight.
5. Replace the electrical access panel.
Match wire colors to
terminals as shown.
GREEN
Attach ground wire
as shown
ERV Electrical
Access Panel
Wires to power plug.
Pre-wired at factory.
Do not modify.
BLACK
WHITE
To power wires/conduit.
Connect other end of
wires to blower terminal
block.