Installation Instructions ERV/PRV Downdraft Vent READ AND SAVE ThESE INSTRUCTIONS TESTED IN ACCORDANCE wITh ThE LATEST EDITION OF ANSI z 21.1 STANDARD FOR hOUSEhOLD gAS COOkINg APPLIANCES, ANSI/UL 858 hOUSEhOLD ELECTRICAL RANgES, CAN/CSA-C22.2 NO. 64 STANDARD FOR hOUSEhOLD ELECTRIC COOkINg AND LIqUID hEATINg APPLIANCES, AND UL 507 ELECTRIC FANS. CONVENTIONS USED IN ThESE INSTRUCTIONS wARNINgS: Must be followed carefully to avoid personal injury or damage.
Do not use to exhaust exhaust air into spaces within Servicer at (800) 772-7778, hazardous or explosive walls or ceilings or into attics, or at www.dacor.com for materials and vapors. crawl spaces or garages” examination, repair or adjustment. wARNINg:...
Verifying the Package Contents Installation Planning wARNINg: • Use and Care Manual A qualified technician must complete the Failure to disconnect power may • Anchoring Legs installation of this appliance. Proper installation result in electrical shock or fire is your responsibility. hazard! If the electric service Overall Dimensions provided does not meet the...
Page 4
Thermal breaks, such as a Maximum Equivalent Straight Lengths Model Duct short section of non-metallic Size REMP3 REMP16 duct, should be used in areas 8” 50’ 60’ of extreme cold. ERV/ 10” 40’ 70’ A back-draft damper at the duct outlet may also be required.
ERV48 - 43 1/2" (1105mm) Backsplash to the particular appliance being installed. Max.3/4" (19mm) The DACOR Raised Vent System is designed to remove the contaminants and by-products 2 13/16" that result when cooking with gas or electric 21 3/8"...
Connecting the Exhaust Duct Dacor Cutout Cutout Model No. “A” “B” NOTE: CER304 28 1/2” 27 1/2” Use duct tape to seal the CER365 34 1/2” 33 1/2” connection between the blower ETT304 28 1/2” 27 1/2” outlet and duct. Support the duct ETT365 34 1/2”...
ERV/PRV 120VAC, 60Hz, 15A 48” (1219mm) power cord with three prong grounded plug REMP Wiring of ERV/PRV with REMP Verifying the Operation Make all electrical connections between the vent and blowers, then connect power to the vent as per the wiring diagrams. Use wire nuts wARNINgS: provided and electrical tape to secure all wiring If the vent system is not...
Need help?
Do you have a question about the ERV30 and is the answer not in the manual?
Questions and answers